Как восстановить данные с флешки?

На флешке включен режим только чтение.

Вывод lsusb
Bus 002 Device 030: ID 0dd8:f607 Netac Technology Co., Ltd OnlyDisk U208 1G flash drive [U-SAFE]

Лог dmesg

[187833.935636] sd 8:0:0:0: [sdb] Attached SCSI removable disk
[187845.004188] usb 2-1.2: new high speed USB device using ehci_hcd and address 14
[187845.100453] scsi9: usb-storage 2-1.2:1.0
[187846.099473] scsi 9:0:0:0: Direct-Access USB Flash Drive 1100 PQ: 0 ANSI: 0 CCS
[187846.100359] sd 9:0:0:0: Attached scsi generic sg2 type 0
[187846.103684] sd 9:0:0:0: [sdb] 3962880 512-byte logical blocks: (2.02 GB/1.88 GiB)
[187846.105123] sd 9:0:0:0: [sdb] Write Protect is off
[187846.105130] sd 9:0:0:0: [sdb] Mode Sense: 43 00 00 00
[187846.105134] sd 9:0:0:0: [sdb] Assuming drive cache: write through
[187846.108699] sd 9:0:0:0: [sdb] Assuming drive cache: write through

Когда вставляю флешку, то в папке /dev/ появляется новое устройство sg1, но оно через некоторое время исчезает

Вот более полный лог

[ 3175.724617] usb 2-1.2: new high speed USB device using ehci_hcd and address 11
[ 3175.821215] scsi6: usb-storage 2-1.2:1.0
[ 3176.819805] scsi 6:0:0:0: Direct-Access USB Flash Drive 1100 PQ: 0 ANSI: 0 CCS
[ 3176.821349] sd 6:0:0:0: Attached scsi generic sg2 type 0
[ 3176.825045] sd 6:0:0:0: [sdb] 3962880 512-byte logical blocks: (2.02 GB/1.88 GiB)
[ 3176.826499] sd 6:0:0:0: [sdb] Write Protect is on
[ 3176.826506] sd 6:0:0:0: [sdb] Mode Sense: 43 00 80 00
[ 3176.826510] sd 6:0:0:0: [sdb] Assuming drive cache: write through
[ 3176.829691] sd 6:0:0:0: [sdb] Assuming drive cache: write through
[ 3206.902610] usb 2-1.2: reset high speed USB device using ehci_hcd and address 11
[ 3221.944844] usb 2-1.2: device descriptor read/64, error -110
[ 3237.090753] usb 2-1.2: device descriptor read/64, error -110
[ 3237.266433] usb 2-1.2: reset high speed USB device using ehci_hcd and address 11
[ 3252.308475] usb 2-1.2: device descriptor read/64, error -110
[ 3267.454381] usb 2-1.2: device descriptor read/64, error -110
[ 3267.630024] usb 2-1.2: reset high speed USB device using ehci_hcd and address 11
[ 3278.017351] usb 2-1.2: device not accepting address 11, error -110
[ 3278.089461] usb 2-1.2: reset high speed USB device using ehci_hcd and address 11
[ 3288.476624] usb 2-1.2: device not accepting address 11, error -110
[ 3288.477197] sd 6:0:0:0: Device offlined — not ready after error recovery
[ 3288.477206] sd 6:0:0:0: [sdb] Unhandled error code
[ 3288.477209] sd 6:0:0:0: [sdb] Result: hostbyte=DID_ABORT driverbyte=DRIVER_OK
[ 3288.477214] sd 6:0:0:0: [sdb] CDB: Read(10): 28 00 00 00 00 00 00 00 08 00
[ 3288.477225] end_request: I/O error, dev sdb, sector 0
[ 3288.477230] Buffer I/O error on device sdb, logical block 0
[ 3288.477289] sd 6:0:0:0: rejecting I/O to offline device
[ 3288.477321] sd 6:0:0:0: rejecting I/O to offline device
[ 3288.477342] sd 6:0:0:0: rejecting I/O to offline device
[ 3288.477360] sd 6:0:0:0: rejecting I/O to offline device
[ 3288.477370] ldm_validate_partition_table(): Disk read failed.
[ 3288.477383] sd 6:0:0:0: rejecting I/O to offline device
[ 3288.477406] usb 2-1.2: USB disconnect, address 11
[ 3288.477415] sd 6:0:0:0: rejecting I/O to offline device
[ 3288.477439] sd 6:0:0:0: rejecting I/O to offline device
[ 3288.477460] sd 6:0:0:0: rejecting I/O to offline device
[ 3288.477469] Dev sdb: unable to read RDB block 0
[ 3288.477534] sdb: unable to read partition table
[ 3288.477679] sd 6:0:0:0: [sdb] Attached SCSI removable disk
[ 3288.572697] usb 2-1.2: new high speed USB device using ehci_hcd and address 12
[ 3303.614763] usb 2-1.2: device descriptor read/64, error -110
[ 3318.760682] usb 2-1.2: device descriptor read/64, error -110
[ 3318.940262] usb 2-1.2: new high speed USB device using ehci_hcd and address 13
[ 3333.982584] usb 2-1.2: device descriptor read/64, error -110
[ 3349.128476] usb 2-1.2: device descriptor read/64, error -110
[ 3349.304109] usb 2-1.2: new high speed USB device using ehci_hcd and address 14
[ 3359.691283] usb 2-1.2: device not accepting address 14, error -110
[ 3359.763354] usb 2-1.2: new high speed USB device using ehci_hcd and address 15
[ 3370.150469] usb 2-1.2: device not accepting address 15, error -110
[ 3370.150662] hub 2-1:1.0: unable to enumerate USB device on port 2