E1 0/1/0 is down.
Applique type is Channelized E1 - balanced
Far End Block Errors Detected
Receiver has remote alarm.
alarm-trigger is not set
Version info Firmware: 20100222, FPGA: 13, spm_count = 0
Framing is CRC4, Line Code is HDB3, Clock Source is Line.
Data in current interval (9 seconds elapsed):
2 Line Code Violations, 1022 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 9 Unavail Secs
sh isdn status
ISDN Serial0/1/0:15 interface
******* Network side configuration *******
dsl 1, interface ISDN Switchtype = primary-net5
Layer 1 Status:
SHUTDOWN
Layer 2 Status:
TEI = 0, Ces = 1, SAPI = 0, State = TEI_ASSIGNED
Layer 3 Status:
0 Active Layer 3 Call(s)
Active dsl 1 CCBs = 0
The Free Channel Mask: 0x00000000
Number of L2 Discards = 0, L2 Session ID = 4
Total Allocated ISDN CCBs = 0
Физику проверили, должна работать. А оранжевый индикатор светит, если даже патч-корд выдернуть из порта.
E1 0/1/0 is down.
Applique type is Channelized E1 - balanced
Far End Block Errors Detected
Receiver has remote alarm.
alarm-trigger is not set
Version info Firmware: 20100222, FPGA: 13, spm_count = 0
Framing is CRC4, Line Code is HDB3, Clock Source is Line.
Data in current interval (9 seconds elapsed):
2 Line Code Violations, 1022 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 9 Unavail Secs
sh isdn status
ISDN Serial0/1/0:15 interface
******* Network side configuration *******
dsl 1, interface ISDN Switchtype = primary-net5
Layer 1 Status:
SHUTDOWN
Layer 2 Status:
TEI = 0, Ces = 1, SAPI = 0, State = TEI_ASSIGNED
Layer 3 Status:
0 Active Layer 3 Call(s)
Active dsl 1 CCBs = 0
The Free Channel Mask: 0x00000000
Number of L2 Discards = 0, L2 Session ID = 4
Total Allocated ISDN CCBs = 0
Физику проверили, должна работать. А оранжевый индикатор светит, если даже патч-корд выдернуть из порта.